slings assembled with wire rope clips are not to be used for lifting. the required minimum number of clips can be installed according to the instructions below.
Wire rope clips, sometimes called u-bolt clamps, are used to clamp the loose end of a length of wire rope, once it has been looped back to form.
Apply U-Bolt over dead end of wire rope – live end rests in saddle (Never saddle a dead An alternate method is to use twice the number of clips as used for a the wire rope end termination should be inspected periodically for wear, abuse.
There's only one right way to install cable clips when you want to get right- sized clip for the wire rope diameter. Demonstrate proper installation step-by- step.
MALLEABLE WIRE ROPE CLIPS - APPLICATION INSTRUCTIONS loads, such as lifting slings, support lines, guy lines, towing lines, tie downs, scaffolds, etc.
Please see our Wire Rope Clip Knowledge Base for proper installation instructions. angelabenton.me has a full line of wire rope clips in galvanized, zinc plated.
U-bolt Clips. There is only one correct method for attaching U-bolt clips to wire rope ends, as shown in The Right Way image below. The base of the clip bears.
periodically for wear, abuse, and general adequacy. WIRE ROPE TERMINATIONS. Warnings and Application Instructions For U-Bolt Clips. 4. WARNING.
Read and understand these instructions before using clips. • Match the same size clip to the same size wire rope. wear, abuse, and general adequacy.
Two simple formulas for figuring the number of wire rope clips needed are as When an eye is made in a wire rope, a metal fitting, called a thimble, is placed in the eye, as shown in figure The thimble protects the eye against wear.